WIL-RICH Chisel Plows

Vertical Tillage Attachment

This attachment allows you to convert your Wil-Rich chisel plow into a vertical tillage tool - perfect for managing today's high residue farming. The attachment uses wavy coulters that can be attached to the chisel plow shank in place of points or sweeps. The down pressure on each shank stays uniform across the entire chisel plow. The shanks also act as a scraper for the coulters, so no extra equipment is needed to till wet and sticky soils. 7-10 HP per foot is recommended because of the high speed required.

Why use Vertical Tillage?

• Aerate and warm spring soil for earlier planting in cold and wet conditions.
• Mixes residue with soil to control erosion.
• High Speed: 8-12 mph equals less time preparing your field.
• Conditions soil in high residue before or after fall tillage preparations.
• Designed for heavy trash at high speed.

3-Bar Heavy Duty Coil Tine Harrow

Optional finishing attachment is available for leveling soil and residue distribution.

• Five Tine Angle Adjustments
• Five Harrow Height Adjustments
• 5/8" Diameter Wire
• 26" Long Tooth
• Spring Loaded Harrow Arms

5810 & 5830 Level Lift Hitch Chisel Plow

The Wil-Rich 5810 & 5830 Series Chisel Plow is a strong, solid workhorse built for better performance, greater strength, and longer life.

Standard Features:

• Level lift for easy field adjustment to tractor draw bar
• 10' and 13' main frames
• Cutting width from 10' to 45'
• Optional mud scrapers
• Auxiliary implement hitch (Optional)
• Stabilizer gauge will assist in uniform working depth from front to rear
• Single point depth control (optional)
• 650 lb. trip force spring shank assembly with 32" clearance
• 1000 lb trip force shank assembly with 30" clearance

5850 Floating Hitch Chisel Plow

The Wil-Rich 5850 Floating Hitch Chisel Plow is a strong, solid workhorse built for better performance, greater strength, and longer life.

Standard Features:

• Floating hitch
• 13' main frame
• Cutting width from 49' to 59'
• Vertical folding inner wings
• Cat hitch with 2-1/4" pin hole
• Four wing lift cylinder on inner & outer wings
• 110 in. front to rear
• Scew type jack
• Main frame; Tandem axle with 2-1/2 in. spindle and 8-bolt hub (Less Rims & Tires)
• 4-bar welded frame
• Depth Control; Top bypass hydraulic system
• 4-1/2 in. O.D. main axle
• Wing frames; Tandem axle with 2 in. spindle and 6-bolt hub (Less Rims & Tires)
• 4 x 4 in. tubular frame
• Front mounted hydraulic controlled castering gauge wheels main frame and wings

[Go Back]